Lnksys velop setup without app

First, link your Linksys Velop device to the power source. After that, connect one of the Linksys Velop nodes to the modem. For this connection, you will require an ethernet cord. Verify that both gadgets must be turned on. Check all the cable connections, if it is unable to detect any internet connection. Settle the Linksys Velop node at all the different corners or areas of your office and house. Between each Linksys Velop node and a WiFi-containing gadget such as a computer, laptop, etc make sure that there is an active internet connection. The LED of each Linksys Velop node turns into a solid blue. Now, take the computer and link it to the router network. Open the Navigation and enter the IP address of the velop in the URL bar. At the back of the Linksys Velop device, you get the IP address. Under the connectivity tap on the CA setup and hit on configure a new WiFi device. In the end, consider all the display instructions and finish the setup process. 

Hence, the Linksys Velop setup without app process is now completely done.